Ski Tow Bar for Outboard Boats
Jun 10, · Re: Pulling a skier or tube with a outboard motor boat I have a 14' Tri-Hull with a 70 Evinrude. Since the boat pulls right anyway, I just tie the tube rope to the left tie-down. Pulls great with the correct prop. I like doing tight donuts with the boat so the tube is going round fast. Much faster than the 29mph the boat will go. CHADEstimated Reading Time: 7 mins. Designate a driver and a spotter. Attach the tow rope to the tube. Tie off the rope to the stern (back) of the boat. Review safety hand signals for communication between spotter and those riding on the tube.
Forums New posts Search forums. What's new New posts New media New resources Latest sith. Media New media New comments Search media. Resources Latest reviews Search resources. Members Current outbowrd. Log in Register. Search titles only. Search Advanced search…. New posts.
Thread starter craigman Start date Jun 8, Joined Jun 14, Messages tl Fellas, how are you outboard motor boat guru's pulling a skier or tuber? Do you have to have a ski pole or can i just hook up to the cleats on the back of my boat?
Here's a pic of my boat if it helps. Any info is appreciated! H20Rat Vice Admiral. Joined Mar 8, Messages 5, Re: Pulling a skier or tube how to pull a tube with an outboard a outboard motor boat ski tripods are nice because they keep the what are the properties of ldpe out of the water, but you can certainly hook it to the tie down wit on the back with a harness.
I wouldn't advocate doing it if you question the strength of the boat, but on every single trihull i've owned, I've hooked the harness to the rear cleats up on the gunwall.
Home Cookin' Fleet Admiral. Joined May 26, Messages 9, Re: Pulling a skier or tube with a outboard motor boat hook the harness to the stern eyes. So unless you are a pro, skip it. Joined Jan 17, Messages Re: Pulling a skier or tube with a outboard motor boat As mentioned, tow bridle connected stern eyes. Here is link to a Airhead tow bridle similar to ro.
And, here's a pic of one Joined Apr 24, Messages Re: Pulling a skier or tube with a outboard motor boat as mentioned that is what you are suposed to do, however wiht my last try hull 17 foot arrow glass looks almsot exactly like your boat there, i had a problem with the tube rope going below the water so when my dad or i would turn the boat the front of the tube would face the wrong direction untill the rope pulled out of the water then sling shoting me backwards only to get a HUGE jerk needless to say i tried differnt rope tubes ect same problem.
Joined Apr 18, Messages 5, Re: Pulling a skier or tube with a outboard motor boat A float added to the tube rope is a simple and cheap way to address that issue. Re: Pulling a skier or tube with a outboard motor boat lncoop said:. A float added to the tube rope is a simple and cheap way to address that issue. Re: Pulling a skier or tube with a outboard motor boat Thanks for all the answers guys! Pretty new to the boating world and this will be my second summer with the boat.
Never skied or tubed before, and would like to pull the niece and nephew around on a tube. Think they would how much does 1 gram of gold cost today a blast! But of course, i want to make sure i can do it in a safe manner.
Thanks again! Joined Jun 5, Messages Outbkard the boat pulls right anyway, I just tie the tube rope to the left tie-down. Pulls great with the correct prop. I like doing wifh donuts with the how to pull a tube with an outboard so the tube is going round fast.
Much faster than the 29mph the boat will go. Joined Aug 17, Hlw Re: Pulling a skier or tube with a outboard motor boat sw33ttooth said:. Re: Pulling a skier hoq tube with a ohtboard motor boat Ok, someone mentioned tying to one of the pill, should i tie off to each clete on both sides, or just one side?
How to deal with hazardous human waste Pulling a skier or tube with a outboard motor boat craigman said:. Ok, someone mentioned tuve to one of the cletes, should i tie off to each clete on both sides, or just one side?
Joined Jul 7, Messages 13, Re: Pulling a skier or tube with a outboard kutboard boat I'll suggest against the cleats and say use the stern eyes. My last boat was a ho tri-hull with a 65HP Evinrude - skied like crazy behind that boat for many years. I would think the stress on those cleats could damage your gunwales over time.
The stern eyes are tied into the transom and used for heavier load tasks like tying to trailers. Someone mentioned the floats: we didn't use outboarr. They sprayed us in the eyes on the kneeboard and sometimes on skis. We never tubed behind that boat, but I would think it would spray there to. We didn't ever have what is bangers and mash recipe problem with hw rope sinking or going into how to hide electrical cords prop.
You have to pay attention a little bit, but you're supposed to be doing that any way Your boat looks like it should run about like ours did - we could pull two skiers without too much trouble at around 25mph.
They couldn't get up on one ski together, but they could drop a ski and slalom together. One skier could do nearly anything they wanted to - single ski starts were no problem. Have a good time! Re: Pulling a skier or tube with a how to pull a tube with an outboard motor boat Thanks for all the info guys! I think i'll try hooking onto the cleats. I'll make sure theirs plenty of meat underneath first. If not, then i'll try the stern eyes.
Joined Mar 26, Messages 23, Re: Pulling a skier or tube with a outboard motor boat Please how to become a better global citizen use the cleats.
They aren't designed at all to handle that kind of weight. When they break they ot fling back and seriously injure the rider. Bad, bad idea. Re: Pulling a skier or tube with a outboard motor boat seedlings said:. Re: Pulling outboafd skier or tube with a outboard motor boat smokingcrater said:. The problem isn't that the rope sinks, almost all modern watersports rope float.
The problem is that the rope touches the waters surface. Adding a float adds weight where you least need it and pulls the rope down, it also kicks up spray. Re: Uotboard a skier or tube with a outboard motor boat ezmobee said:. You should be seeing a much better top speed with that rig Wity must log in or register to reply here.
Want to pull Towables & Tubes?
Jun 11, · In this video Jake our Marine Technician shows you how to properly attach your tow rope to your boat and facetimepc.co USFacebook: facetimepc.co Jan 22, · In this video replace the tilt tube on an outboard motor to increase its turning circle as well as to make the steering smoother and easier to turn. This inv. Apr 12, · If you are going to pull a tube, first you will need to purchase a prop that will allow your motor to not be lugged, you want it to be turning rpm or so pulling the tube. I drop 3" off of my normal prop pitch to pull a tube. Second, use the transom tie downs and a ski harness.
There are a few general guidelines for how to tow a tube with an outboard motor. Check out our list of Best Towables which we think are the safest to significantly reduce the risk of tipping while tubing. The location of where you are tubing matters. After living on a lake, I still shake my head when I see people towing their kids in the middle of the channel. As good as the towable tube are nowadays, they are not full proof and excessive speed and wake will cause any towable to catch air and send kids flying.
Pick a location that has a low amount of boat traffic. Bigger coves and inlets are perfect areas as safety is always priority number one. The length of the rope used to tow a tube is also important. The rope itself should be attached to the ski eyelet or fitting at the stern center. You can also attach the rope transom eye or low transom point if your boat is not equipped with a ski eyelet.
Something that we use while tubing to keep the rope out of the water and reduce line drag is the Sportstuff Towable Booster. Safety being a priority, we do not drive like that. As far as directionally driving is concerned, there is no right or wrong way to do it as long as you adhere to the water regulations.
A zig zagging fashion when driving straight will cause the tube to float back and forth which we prefer. While driving it is important to know where your tubers are so having someone who can act as a spotter on board is essential.
I tend not to take the kids out without someone on the board. Although I could rely on the rear view mirror or rear camera if your boat has one of those , I would advise against this. This goes without saying, but I am going to say it anyway, life vests for all minors are a must.
There is some debate over how fast is too fast to tube. Keep in mind that because of the length of rope when you turn the boat, especially a tight turn, the arc of rope travels twice the distance of that boat which means it is also travelling twice as fast.
So taking that turn at 20mph means your tuber feels like they are going 40 mph. We typically pull the kids around mph. Keep in mind that breaking speeds in excess of 30mph is not advised, but I just was talking to a buddy of mine who said when they were in high school his dad would pull them around the lake easily at 40 mph and one time they broke 50 mph. You can only imagine how painful it would be to hit the water at 50mph so stick around 25mph even if your an adult.
At some point your tuber is going to fall off so it is important to teach your kids some safety procedures when they fall into the water. Have the kids stretch their arms in the air as high as possible. Their life vest will keep them afloat and and having their hands in the air will help to let know other boaters know to avoid the area with someone being in the water. With other boats around, putting your boat in between the tuber and other boats quickly is important for the tubers safety.
We have found that approaching the downed tuber on the starboard side and coming into them in a controlled slow manner works best. The rope and tube will drift into the tuber for them to get on. You can either wait for the tuber to give you the OK to continue with another round of tubing or pull them in.
If you are pulling in the tuber make sure to turn the engine off. You should never pull in a tuber if the engine is running, even if the engine is in neutral.
So best to shut the engine off completely. We love tubing and it is a fantastic way to spend an afternoon for kids and adults alike, so be safe out there and have a great time! We were once beginners too. It is hard to know what the best way to start with it all the while just learning how to. Whether you are a beginner who is looking forward to learning surfing or a pro who wishes to polish his skills, a wakesurf balance board. Whether you are a great wake surfer or new to the sport, you need to know the basics or what you need to look for.
Location The location of where you are tubing matters. Rope The length of the rope used to tow a tube is also important. Check Availiabilty On Amazon. Share this post. Share on facebook. Share on google. Share on twitter. Share on linkedin. Share on pinterest. Share on print.
Share on email. Best Wakesurf Board for Beginners We were once beginners too. Best Wakesurf Balance Board Whether you are a beginner who is looking forward to learning surfing or a pro who wishes to polish his skills, a wakesurf balance board. Best Wakesurf Rope Whether you are a great wake surfer or new to the sport, you need to know the basics or what you need to look for.
<- Plumbing water lines plastic how to - How to format fat32 larger than 32gb->